Paul
I just ran across a strange press release dated March 16 stating that Moller
is doing a contract (study?) with P & W on a compound rotary engine.
Somebody at Moller/Freedom Motors must keep an eye on this board.
best,
George W
-----------------------------------------------------
Oh no! Kiss of death!
Yes they have been on here for years despite my bad mouthing
them every once in awhile :)
If true P&W won't get their money's worth. IMHO they did a bad
job on the NASA side housing wear coating contract running the
rotary engine for only a couple of dozen hours as I recall.
Of course it could be just another ploy to sell some
more worthless paper.
Where was the press release published? Can you scan it?
Robin has some higher up friends at P&W. Maybe she can find
out more.
BTW just finished reading Graham White's great new book "R-4360
Pratt & Whitney's Major Miracle". Curtis Wright blew P&W
out of the water in the commercial airliner engine market back
in the 50's with the R-3350 turbo compound. P&W's excuse
was they were pre occupied by the turbojet which of
course they were.
The R-4360 was too troublesome, burned too much gas
and had a limited TBO of around 1200 hours if you were lucky.
The CW R-3350 TC would go 2000 hours or more if operated
properly, generated about the same 3800 HP and burned way
less fuel. Turbo Compound is the replacement for displacement :)
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.