All you Solid Works guru's out there.
I need to mill out these four pockets
from the back of this part. How do I do that
in Solid Works?

BTW I do most of the drawing in Rhino
and let Solid Works do the fillets as it does fillets
better than Rhino.

Thanks.

Paul Lamar ...No rotor no motor.

send away Paul, I'll see if I can help ya  :-)


Jarrett

Thats OK I need to learn how to do it myself.
The Rhino part had a defect. I'll probably just
draw it over. Seems quicker than drawing it in SW.

So far drawing parts in SW is T E D I O U S :)
I think it is a plot by the French to destroy our
engineering productivity :)

Something simple like "snap to" would speed things up.
So far I have not found snap. Is snap in there someplace?

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.