Jarret, What are SW laminar edges and how do you fix them
so they can be filleted? SW refuses to fillet this edge.
The first two jpgs are SW renderings drawn in Rhino
and exported to SW as an igs's.
The last jpg was exported from SW as a igs
and loaded into Rhino and rendered. Unfortunately it is
a collection of un joined surfaces.
So SW becomes the ultimate filleting utility for Rhino :)
These fillets are impossible in Rhino.
Now I hope Surf Cam does not have any trouble with
this SW file.
Pascal, I did what you suggested and that worked.
One problem. When you "check" the original Rhino part
it says everything is OK. When you do a mass properties
volume it says some of the selected objects are not
closed. How do I find those and close them?
Paul Lamar ...No rotor no motor.
Laminar edges is an error where the two surfaces that are to be filleted, are not
controlled enough to be able to generate a fillet solution. I think in this case it has
to do w/ the imported solids. Because there is no dimensionally constrained data upstream of the
import, it doesn't know for sure exactly how to resolve the surface. You'll notice on the import
that the interior faces all the way around to the flange face is one big complex surface, I think
this is where the error is coming from. Do you have any drawing data that you can send me on
this part? I'll try re-creating it in SW and see if it gives the same error when using solidworks
build
geometry. Usually where this error comes from is during complex lofting, I've not seen it on a
revolve and extrude such as this, it should do it no problems or questions asked.
Jarrett
I think what you need is the history file.
I'll send that and the igs file under separate cover.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.