Subject: SW ultimate filleting utilty for Rhino?
From: Rotary Engine
Date: 4/17/2006, 2:10 PM
To: AAme



Jarret, What are SW laminar edges and how do you fix them
so they can be filleted? SW refuses to fillet this edge.
The first two jpgs are SW renderings drawn in Rhino
and exported to SW as an igs's.

The last jpg was exported from SW as a igs
and loaded into Rhino and rendered. Unfortunately it is
a collection of un joined surfaces.

So SW becomes the ultimate filleting utility for Rhino :)
These fillets are impossible in Rhino.
Now I hope Surf Cam does not have any trouble with
this SW file.

Pascal, I did what you suggested and that worked.
One problem. When you "check" the original Rhino part
it says everything is OK. When you do a mass properties
volume it says some of the selected objects  are not
closed. How do I find those and close them?

Paul Lamar ...No rotor no motor.


Paul, I've redrawn it as close as was needed just for a trial. Complete model done in SW, attached are
the photo's of the surfaces. I can send you the file if you'd like, you can then move through the various
sketches and modify the dim's as needed to get the sizes you want.  I worked when I went
from start to finish in SW.

Jarrett

Looks great. Nice fillet in there. Thanks. I'll check the dimensions.
Send the solid. We will see if it will go into Surf Cam
How long did it take?

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.