Subject: Megasquirt PC boards are in
From: Rotary Engine
Date: 4/20/2006, 4:45 PM
To: AAme



Presently surprised to find they are smaller than I
thought.

The upper left board is the Stimulator allowing you
to set up
and exercise the complete EFI system on the bench.
Don't leave home without it.


Lower right board is the relay board that simplifies
the
wiring.

Last jpg is the CPU board with CPU and manifold
pressure
sensor. These are small enough so two would be no
burden.
http://www.megasquirt.info/

Paul Lamar ...No rotor no motor.

Paul,

If you think that board is small, check out the
MicroSquirt, which is about 1/3 the size of your
Megasquirt board.  It's a surface-mount version of the
MS, with integral that will be sold pre-built for
around $350.  Dimensions including connector are 2.4"
x 3.5"!

http://www.microsquirt.info/

Have fun soldering!

Roger.


I am an old hand at soldering. No problem.
The trouble with surface mount it is near impossible to repair.
It is cheaper to throw it away.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.