Paul,
My Renesis has been moved forward 8" on my RV10. As a result I have 15"
between the pulleys and the firewall. Studying high pressure areas on
aircraft there seems to be almost as much high pressure at the base of
the windscreen as on the nose of the plane. I was wondering if this area
could be used to feed a radiator. Any experience with this method in
race cars?
Bobby
I am going to be brutally frank. DO NOT ATTEMPT TO FLY WITH
THAT MOTOR MOUNT. If you bought it... DEMAND your money back!
Motor mounts are subjected to 6 G's vertical load.
Since the engine PSRU prop and all accessories add up to
close to 300 pounds and the Cg of the combination is near
the rear (in the car) end housing there is a 1800 pound down
load on the end of this mount. I guarantee it will bend or worse
case break. If you wish to verify this you can try
to pick up the front of a 3000 pound car using this
motor mount static test diagram. The top and bottom
diagonal tubes MUST intersect this CG point in the
vertical plain.
Yes the base of the center of the windshield is a high pressure
point but it rapidly becomes low pressure as
you move outboard on both sides due to high speed
lateral airflow around the base of the windshield
and around the side of the cabin. You need to think
of it in 3D.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.