Jerry,
   Paul designed my original engine mount using a S-beam that is
22.2" Barry mount hole centers and 24.2" overall length. I am not
sure if this is the final version as I think he is waiting for some
dimensions from a Renesis exhaust manifold. Whatever the final
dimensions end up being I would just as soon pay you to cut it rather
than take it to a machine shop. When it is ready to ship send me a
bill and your address.
Thanks,
Randy

22.2" center to center is fine Randy. I crawled under
my RX8 and measured the stock exhaust manifold. It will
fit fine.

--  Paul Lamar ...No rotor no motor.

O.K Randy.  I will cut one down to  22.2 Inches between centers. Send
me your e-mail address and  shipping address.   I hope you are not in
a big hurry.  It will probably take about two weeks.     Jerry

jerryhey@earthlink.net


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.