Paul,

I'm looking for a cad (dxf) profile of the V grooves for multi-groove
belts. Is this something you have?

Thanks
Ken Bauman

No but I have a multi V grove pulley set from McMaster Carr
I will be using on the turbo compound engine.
In .92 inches of width there are 10 grooves.
The depth is about .090". Hard to measure exactly. I might
be able to take it over to the machine shop and put it on
the optical comparator if it is real important to you.

This looks like a much finner pitch than the units used
on the new car engines to drive the water pump and
alternator. I don't have any of those lying around.

When I drew it I did not take the trouble to model
it exactly.

Paul Lamar ...No rotor no motor.

Machinist Handbook has them, I don't have a
scanner, however I might be able to take a picture
and send that. Not sure on the page either, but
I'll look it up tomorrow.

Jarrett

I have Mac Hinnery's hand book.

Here it is.

Paul Lamar ...No rotor no motor.

Thank you

Ken

Ken, I think this is the web site you are looking for.

-------------------------

I take it back. That Gates web site sucks. Who ever heard
of having to register before you can download a pdf catalog.
The on line catalog is ridiculous as well. Sometimes these
people shoot them selves in the foot.

Here is a better one.

http://www.cptbelts.com/products/vribbed/vee_rib/index.html

You want a 3D DXF or a 2D DXF ?

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.