Where do you smack the flywheel. I used a gear puller, a big hammer and
heat and it was still a struggle.
Lowe's quoted me $65.00 for a 55mm socket and I ended up buying a
big metric set, that only went up to 50mm, for the breaker bar and
ratchet and a large SAE set for the 2 1/8 socket from Harbor Freight for
about $75.00. Karibian

Out near the edge of the flywheel. Use a bigger hammer.
Try a ten pound sledge.

Mc Master gets $28 for a 2 1/8 inch 3/4 drive impact socket.
They get $30 for a 3/4 drive sliding T  handle.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.