Subject: Oil Pan & sensors
From: Rotary Engine
Date: 5/1/2006, 8:48 PM
To: AAme


>Hi Paul,
>
>I started to take my 13b 1986 apart,
>I noticed the oil pan has been hit and is enbossed
>at least at two places, I will replace it.
>
>What about the sensors inside the oil pan though?
>What are they? oil level or temp? and will they be used
>on the RV7a?
>
>Thanks
>
>JP


>They are oil level. I have never had one apart so I have no idea
>how they work.
>
>--
>Paul Lamar ...No rotor no motor.

   They are a simple float and contacts, pull the three bolts and you
have the whole thing in your hand and its all open and exposed.
   Ken

Well I'll be! You are right again Ken :)

Just a simple float and contact system.
The float is some sort of conductive plastic
rigid foam. The brown parts are insulation.
When the float goes up it opens the circuit.
When the oil level drops and the float goes down
it grounds the wire.

Paul Lamar


If you look at that again, you will see that the contact isn't quite so
obvious.  There is a magnetic switch inside the tube the float rides up
and down on.  The pieces that look like they are making contact are
actually electrically isolated from everything.  Those things are pricey
too.  I got a deal on one at dealer price of about $120, then found out
I could have fixed the old one.  The lead was broken off.

Bob W.

-- 
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (first engine start 1/7/06)
Custom Cables for your rotary installation -
http://www.roblinphoto.com/shop/

Yep. I dug up my ohm meter and measured the plastic.
Sure enough it is an insulator.

Well I 'll be double darned it is more sophisticated than
it looks.

It would be nice if someone made up a kit that controlled a
cluster  of bright red LED's on the instrument panel warning
of a low oil level.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.