Subject: Multi groove belt
From: Rotary Engine
Date: 5/2/2006, 9:13 AM
To: AAme


Do yourselves a favor and search out an Enstrom helicopter to study
their system.  It has been in use for a very long time with great
success.  Enstrom uses the belt as the clutch and this solves the tension
problem for Enstrom.  The polyV provides damping of torque pulses.  The
system should be no more complex nor heavier than a cog belt system with
the exception of the tensioning device.

This past Saturday I examined the "Belted Air Power" unit on a V8
engine.  It is quite clean and in use for a long time.  However I want
to use the polyV belt system as I think there is less risk of
catastrophic failure.  With the cog belt improper tensioning can raise
havoc with the belt teeth.  The cog belt may not provide the damping
qualities of the polyV belt.

Bob Y

There are way more Robinsons flying then Enstrom :)
Probably a 100 times as many :)

The V-ribbed provides damping too. Probably it is more efficient
than a poly V as the belt is thinner so there is less
flex and heat build up. However not recommended for a clutch type
helicopter application.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.