SNIP
I seem to remember, it has been a long time since I've used one, that the
555s were not noted for pulse width stability. As a digital systems
designer, I still lean toward xtal to get the frequency resolution needed
for the pulse width resolution required. A bit more circuitry required,
but my digital rotor speed alarm system has been working in my helicopter
with zero failures for 8 yrs. Even then, if you have to sync to an outside
signal, you will get some pulse width jitter.
Stuart & Kathryn Fields, Publishers
Experimental Helo magazine
IIRC -
Aint there a digital rather than analog version of this
chip that has been in circulation for some years ?
Fly Good - Build good - Bryan
-------------------------------------
Could be. There are a lot of IC's out there.
It would be overkill as the 555 will drive 200 ma.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.