SNIP
> I seem to remember, it has been a long time since
I've used one, that the
> 555s were not noted for pulse width stability. As
a digital systems
> designer, I still lean toward xtal to get the
frequency resolution needed
> for the pulse width resolution required. A bit
more circuitry required,
> but my digital rotor speed alarm system has been
working in my helicopter
> with zero failures for 8 yrs. Even then, if you
have to sync to an outside
> signal, you will get some pulse width jitter.
>
>
> Stuart & Kathryn Fields, Publishers
> Experimental Helo magazine
IIRC -
Aint there a digital rather than analog version of
this
chip that has been in circulation for some years ?
Fly Good - Build good - Bryan
-------------------------------------
Could be. There are a lot of IC's out there.
It would be overkill as the 555 will drive 200 ma.
Paul Lamar ...No rotor no motor.
I take exception the the stability statement. It was a
long time ago, but when I compared various analog type
one-shots, the 555 was by far the most stable.
regards, Robert
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.