Subject: Bushcaddy RX8 engine rear motor mount.
From: Rotary Engine
Date: 5/6/2006, 5:13 PM
To: AAme

Real easy as there is a fifth hard point on
the Bushcaddy firewall.

Rick, you will need a deeper custom oil pan for the RX8 engine
as the stock RX8 oil system spews oil foam out of the breather at
anything over 7000 RPM. This is due to the shallow depth of
the stock pan forcing the oil level higher in the RX8 engine.

Also more oil in the pan takes longer
to heat up when climbing out helping the oil cooling system.
The 10" by 10" by 4" deep oil pan shown is about 1.75 gallons or
seven quarts. Two more than stock. My 230 HP Cont.
O-470 has 12 quarts.

The stock 2nd gen oil pan weighs about 6 pounds so this
oil pan out of .049" thick  steel would weigh about five pounds.
Out of .065" thick aluminum it would weigh about 2 pounds.

There is a very elaborate "crankcase" breather system on the
RX8 car to mitigate the oil breathing problem.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.