Subject: Bushcaddy RX8 engine rear motor mount.
From: Rotary Engine
Date: 5/6/2006, 6:27 PM
To: AAme



   Real easy as there is a fifth hard point on
   the Bushcaddy firewall.

   Rick, you will need a deeper custom oil pan for the RX8 engine
   as the stock RX8 oil system spews oil foam out of the breather at
   anything over 7000 RPM. This is due to the shallow depth of
   the stock pan forcing the oil level higher in the RX8 engine.

   Also more oil in the pan takes longer
   to heat up when climbing out helping the oil cooling system.
   The 10" by 10" by 4" deep oil pan shown is about 1.75 gallons or
   seven quarts. Two more than stock. My 230 HP Cont.
   O-470 has 12 quarts.

   The stock 2nd gen oil pan weighs about 6 pounds so this
   oil pan out of .049" thick  steel would weigh about five pounds.
   Out of .065" thick aluminum it would weigh about 2 pounds.

   There is a very elaborate "crankcase" breather system on the
   RX8 car to mitigate the oil breathing problem.

   Paul Lamar ...No rotor no motor.

Does anyone actually run 12 quarts in a 470?  Anything over 9 seems to
burp out pretty fast.  Maybe the 470 needs the very elaborate crankcase
breather system..

:)

I guess that's why so many of them have separators on them.  How about
your 182 Paul?


Matt-

I do what I am told and use 12 quarts. Check your front
cranshaft oil seal. A Continental rep told me this story. If your
front crankshaft seal is a bit weak dynamic pressure
builds up at the front of the crankcase causing
the front seal to leak and pressurizing the crankcase.
That blows the oil vapor out.

Plausible?    Perhaps?

I had to put an air oil separator on my old engine.

My new -s engine uses a lot less oil than my old -u engine.
Then again the crankshaft seal only has a couple of hundread
hours.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.