*"The IVO prop is also defective
in this regard with very little angle of attack near the hub. "*
Ive read a few comments regarding a least one of the IVO Magnum prop
designs having an upper speed limit of around 180 mph as you mentioned.
Im wondering however, how that propeller would fair if it were made
longer, possibly with 3 blades, and spun slower with the 2.85 redrive.
It is my understanding that the center section does not add a lot of
thrust compared with the outer section.
Next question: Im building an RV-9A. It is supposedly overpowered
with anything over 160HP, according to VAN; but, since I live in Utah,
at ~5000 ft and most of my flying will be around 11-12K over the
mountains around here, Im thinking 180HP might be a reasonable and
easily attainable target with good durability. My thoughts are that a
P-ported 13B engine fits the bill but might be a little overkill,
particularly when fuel injected. The Renesis seems larger/heavier than
I need. Any comments to steer me in the right direction? Has anyone
designed a motor mount for a RV-6A/7A/9A yet with lower radiator/cooling
ducts and James rotary cowling (front wheel strut possibly in the way...)?
Mike Parker
The IVO will work OK if you use a 12 or 14 inch spinner to
block the bad inner part of the blade.
At 8000 feet you are down about 75% of sea level power
with an NA engine. 75% of 200 HP is 150 HP.
The thing about power is you don't have to use it if you
don't want to. Van's real objection is excessive engine weight
I suspect. He assumes you are talking about an aircraft engine
when you are asking about more power. He does not want
you to put in a 400 pound six cylinder something or other.
The normally aspirated rotaries 150 HP to 250 HP all weigh
about the same 300 pounds installed. About the same as a
160 HP Lyc O-320 installed. A turbo rotary is only about 20
pounds heavier due to the weight of the non existing muffler
required being off set by the 16 to 20 pound turbo charger.
The Renesis (RX8 engine) is the same size as the 13B and is
slightly lighter in weight by about ten pounds.
Just about any NA 13B or RX8 engine (There are two kinds. High power
and low power, four port or six port.) will generate 180 HP
as long as the intake manifold is half way decent.
No P-port needed. However a P-port is easier to build
than a six port RX8 engine intake manifold and will
probably burn slightly less fuel for the power generated
due to easier breathing.
We have a MM design for a RV6A but it is not hard to do one
for any of the others you mention.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.