Great article on rotaries vs recip in the May issue
of
Sport Aviation!!!
Dr. Bill Doell
I didn't think it was so great. The conclusion was that the rotaries were
maybe OK, but the fuel consumption was prohibitive. One of the rotaries
burned about 30% more fuel than the O-320 to cover the same distance just a
little bit faster.
Other than that he says the rotary sounds like a outraged
vacuum cleaner.
Al
Sounds like the article in RV Aviator. Of course 30% more fuel
borders on slander :) Perhaps there was something wrong with
the Power Sport fuel injection system. Tracy leans his to .47 BSFC
which is about the same as most Lycoming at .45. Tracy flys side
by side with his buddies in similar RV's in Florida burning
about the same fuel.
30% more fuel is about .58 BSFC. No doubt a full rich rotary
will burn .58 BSFC but then again so will a full rich air
cooled aircraft engine. A turbo charged air cooled aircraft
engine will burn as much as .65 BSFC on takeoff and climb out.
Lets go the other way. Say by some miracle the Lycoming
was leaned past peak to .40 BSFC. 30% more would be .52 BSFC.
Still not plausible. Lycoming does not allow lean of
peak and it voids the engine warranty last I heard.
The rotary will run smoothly as much as 200 degrees lean of
peak with no damage to the non existent exhaust valves if
you screw up and allow it to go to peak EGT :) Tracy's
theory on this is the rotating combustion chamber rotary
engine is naturally stratified charge due to a centrifugal
affect on the mixture forcing the rich portion out towards
the spark plugs.
My RX8 gets 25 MPG at a steady 65 to 70 MPH which is comparable
to other 240 HP cars of the same size. Not 30% more fuel.
BTW Cars are not allowed to run lean of peak for emissions reasons.
The computer holds the mixture at stoichiometric (14.7:1) with in
plus minus .01. See the OBD II data captures. From the
air flow rate in pounds per minute you can calculate
the fuel flow rate in pounds per minute by dividing
by 14.7.
There is also the cooling drag issue. The Power Sport
installation is not known for low cooling drag.
In fact it is not known for effective cooling either :)
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.