Paul,
 I can't remember if this company has been mentioned for epoxy.
http://www.cotronics.com/ien/
Richard

Yes it has and I told told Doug about it :)

In all seriousness Doug, threading the third plug insert will
hold it in and the high temp epoxy will go to at least 300 F
and seal the threads. That part of the rotor housing does
not get to 300 F. JB Weld claims 600 F. You can also tig tack
it around the outside to lock it in place.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.