Subject: manometer on 80 mph plane
From: Rotary Engine
Date: 5/11/2006, 6:41 PM
To: AAme


Learning from your advice I am setting up a water manometer to
help with changes to my rotax 80hp installation in a Rans S7.
Water cooling is OK but I plan to take some of your ideas to
the
oil cooler and general cowling design.

To get an idea of how big the "U"s should be I set one up with
the input out front of the oil cooler with a bit of foam on it
and had the other end open to the cockpit. The differential was
only a couple of inches at 80mph.
Some questions:

Is two inches typical for this environment?

Should I play with the static end?
Would it be more readable if the static end went to the low
pressure side of whatever I was checking like the back of the
oil
cooler or the cowl exit area etc?
Comments appreciated.
If you want to put me back on your list to get answers that
would
be great.Thanks
Peter

The static end is probably OK. Two inches depends on
the configuration. Got any digital pictures?
Two inches is not that far out of the ball park.

Yes measuring the the differential across the core
is a good idea. Use porous foam on both ends.
Also make four U tubes and position them on a grid to check
for uniform flow through the core.

Are you using the Rans oblique cooler scheme?


Paul Lamar ...No rotor no motor.

Yes, the main rad is the belly mounted as in your picture (my
plane is even the same colour).
I will check it but the water cooling is not an issue; it is the
oil. The cooler is just sitting vertically in one nostril with no
aft duct. I plan to remount the oil cooler with both an inlet and
outlet plenum.

So I think I'll  set up four: in front/behind the oil rad and the
coolant rad just for the heck of it; then the third in the other
inlet nostril and the other end in the cowl outlet and the 4th in
the nostril paired with a top cowl exit louver which will be
added to also assist post shutdown cooling. I'll take some pics.
Thanks
Peter

I think you need four U tubes on the oil rad alone. The most
frequent mistake people make is not sealing the duct to the rad.
BTW get one of Paul Lipps's prop and it will cool the oil
better.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.