Hello Paul.
Hope you will consult with me even though I'm away from the
rotary world. I frequently refer people to the cooling article on
your site.
Learning from your advice I am setting up a water manometer to
help with changes to my rotax 80hp installation in a Rans S7.
Water cooling is OK but I plan to take some of your ideas to the
oil cooler and general cowling design.
To get an idea of how big the "U"s should be I set one up with
the input out front of the oil cooler with a bit of foam on it
and had the other end open to the cockpit. The differential was
only a couple of inches at 80mph.
Some questions:
Is two inches typical for this environment?
Should I play with the static end?
Would it be more readable if the static end went to the low
pressure side of whatever I was checking like the back of the oil
cooler or the cowl exit area etc?
Comments appreciated.
If you want to put me back on your list to get answers that would
be great.Thanks
Peter
The static end is probably OK. Two inches depends on
the configuration. Got any digital pictures?
Two inches is not that far out of the ball park.
Yes measuring the the differential across the core
is a good idea. Use porous foam on both ends.
Also make four U tubes and position them on a grid to check
for uniform flow through the core.
Are you using the Rans oblique cooler scheme?
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.