SNIP
...........................................................

As I told Robin recently I am a senior and you have to expect
my memory is not what it once was so there is a law against abusing
seniors. One advantage is you make many more new friends as every
person you meet you think you have never met before :)

Paul Lamar ...No rotor no motor.

OOPS,
Isn't this NewsLetter AARP???

Joel

ROFL
Paul Lamar ...No rotor no motor.

Dear Sir,


In light of your recent relevation I highly recommend flying
airplanes with the landing gear welded in the down position:)

Speaking of welding..... Yes an outside weld on the plug boss
it easy.  My concern is the intersection of the boss and inner
housing liner.  Not much material there to tap into and that
would be the area that coolant would
seep in. I'll take another look at it though.

Doug

When you bore the hole stop just short of the steel liner.
That will give you a large flat area for the slug of aluminum
to epoxy bond to the rotor housing. You will need a real small
hole for the actual spark as when the apex seal passes over
the hole you lose a bit of compression.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.