> Hello Paul
 >
 > I fired up the Renesis with the prop. on yesterday
and was amazed
 > at how
 > quiet it was. That spin [tangential] muffler design
is a real
 > winner, even though
 > mine has only two pipes going in at a tangent with
the third going
 > in at
 > the end, it still works.
 > The flanges shown in the picture were too narrow to
fit the Mazda
 > gasket. Words were spoken!
 >
 > Ian Beadle

I don't recall hearing about a tangential muffler
unless it is the one with the cooling air through it
and the rectangular exhaust pipe. The article I just
read mentioned having only two pipes in it instead of
three.

Hurant

The RX8 engine or Renesis has four exhaust ports.
The two center ones being very close together so it
looks like three pipes.

Paul Lamar ...No rotor no motor.

---
Have you got
1. a picture of this
2. a internal design layout of that muffer with dimensions?

I would like very much to make a couple for my engines, I have been
considering this issue for a while now.

Thanks in advance

Regards David Gaze

There is nothing inside David. Here are a few old 2D's and 3D's.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.