Fuel consumption is becoming more important as time goes on. Noise is
also more important. If the rotary can even make par with the piston
engine it would be my engine of choice. I have no experience with the
rotary but plenty with pistons and I think the turbo-compound using the
rotary will be the configuration that could bring the rotary up to par.
The rotary configuration is a natural as a gas generator because it has
comparatively large port area. Better than a two-stroke cycle piston
engine because the ports open quickly where the piston engine ports are
opening as the piston approaches the bottom of the stroke and the piston
is moving slowly.
The turbo compound can help with the noise as well. I am guessing the
rapid port opening and subsequent blow-down contribute to the noise.
The turbine will suck the energy out of the exhaust.
Bob Y
Bob,
I keep forgetting to mention that the rotary runs fine
on auto fuel which is 75% of the cost of 100 LL while
late model air cooled aircraft engines require 100LL.
My new Cont. O-470 is a good example. 10:1 compression 100 LL
only. This make a P-port rotary engine clearly superior to any
200 to 250 HP aircraft engine in terms of fuel cost
and power to weight ratio despite the 5% fuel burn
penalty.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.