Yes but I wonder if Van will also receive the same
economic benefit he is now getting from Lycoming.
The economy of scale is not with Mistral.
At the current time the rational for installing the rotary
is primarily economic. Until the turbo compound is
perfected and proven this will be the primary reason
people choose to install the rotary.
Power Sport had everything going for them yet they failed
in the market place. We still don't, after seven years,
have critical mass of acceptance for the rotary as
a superior aircraft engine. Part of that is the
5% worse fuel consumption, part is ignorance of why
the kinematics of the rotary are superior, part
the mystery of how the rotary actually works and part
the increased complexity of liquid cooling.
These drawbacks must be mitigated by a clearly superior
solution. This is why I am spending so much of my own money
building and dyno testing the turbo compound rotary
that potentially has the low fuel burn of a diesel
and a vastly superior power to weight ratio advantage
and durability advantage over an air cooled aircraft
engine.
Paul Lamar ...No rotor no motor.
On that note, when someone casts aluminum end plates, it would be a great
time to re-plumb the water jacket into 2 separate systems with each system
adjacent to the other... this would give us a truly fail safe liquid
cooling. Of course a second water pump would be needed and 2 smaller
radiators.
-dave
--
Best Regards /Mit freundlichen Gruessen,
dave ( at ) arb.net
http://arb.net
Fuel consumption is important, and getting more important with
rising costs and growing concern over the environment. But
lowest life-cycle cost is generally the engineering solution,
coupled with availability and reliability.
Who has a thorough analysis that includes other cost factors
such as overhaul cost with TBO taken into account; Annual and
100 hr inspection costs; regular maintenance considering typical
consumables and spares; First costs (even used Lyc compared to
a used Rotary). Then, who has stats to produce a good MTBF figure? I hear more often of a guy who
lands his Mazda on a freeway or in a field than I do of a
Continental or Lycoming letting a pilot down without permission.
Of course that requires stats, too - engine
failures per engine type flying-hour.
Jim
Austin/Houston
A couple of things: Annual inspection does not mean much as these
are experimental aircraft so the owner builder does the inspection.
No $500 minimum IA annual inspection fees.
Over haul if an when it becomes necessary is far far cheaper
for a rotary. If the owner does it parts are less than
1000 including new rotor housings. If you have somebody else
do it it is $1500 to $3500. Dealer cost on brand new RX8
engines is $3800 full pop retail $5800.
TBO: so far nobody has worn one out. Rummors of 2400 hours
are out there. Based on wear rates 2000 TBO is no problem
and 3000 hours looks doable.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.