Paul,  I don't have a Renesis to look at.  In the photo are we
looking up at the bottom of the pan with the flywheel on the right
end?  I know you labeled the "Front Cover End" [(car)] but even  that is
subject to interpretation since we turn the engine around.  Can  you
drawn in the S-beam?     Thanks,  Jerry

As you can see from Scott's picture of the RX8 engine
the right angle corner of the front cover is on
the lower right looking straight down on the engine
facing the back of the engine (car).

I put an X on the pan picture at this point.

From now on I will always use it from the point of
view of the car.

Paul Lamar ...No rotor no motor.

It looks like the pan  bolt pattern for the flywheel end is the same
for the 13B and Renesis.  Can you confirm this?  It would be nice if
only one template were needed for drilling the S-beams regardless of
engine.   Jerry

I have a drawing you can compare to a 2nd gen.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.