I finally got my copy.
As far as I can tell the main fault lies with the Power Sport FADEC,
As Tracy Crook has pointed out many times it is near impossible to
program a FADEC that will optimize the rotary engine air fuel mixture
under all possible conditions. The pilot must intervene and optimize
the rotary engine mixture control for cruise. Unless you lean the
mixture properly (up to 200 F lean of peak) you will not achieve .47
BSFC. The people involved with the test probably had no way of knowing
that.
Paul Lamar ...No rotor no motor.
Hi Paul,
The guys over at the "E-SubieForum" at Yahoo groups are sure "yucking it up"
about the fuel burn Rotary vs. Lycoming, in Sport Aviation.
One guy wrote; "Did anyone else note the amount of fuel those rotaries in
Sport Aviation went through? That kinda leaves them out of the conversion
race I would think..."
Too bad Subies can't produce the HP as advertised, heavy pigs. Funny I think
that would kinda really leave them out.
Regards to All,
Rick in Alaska
I just got off the phone with Ray Richardson owner of Power Sport. He said
the software in the Power Sport FADEC was far from optimized when they
tested those airplanes.
That implies the engines were running too rich.
He also pointed out the test was run at a fixed prop RPM rather than a fixed
air speed. This gave a decided advantage to the metal CS props used on the
Lycoming over the primarily wood CS MT props. The muffler system used was
also not finalized.
These are some pictures of the mufflers I took at OSH which were added after
the test was done well over a year ago. Ray also said they notified Vans of
the changes and nothing was done to correct the results. EAA did not contact
Power Sport prior to publishing the article so corrections could be made.
I also called Jim Clark owner of one of the PS powered RV8 to get his take
on the test. He told me he and the other planes were required to fly
formation on the lead Lycoming powered airplane.
Consequently he felt his FADEC was going in and out of auto rich.
After thinking things over for awhile he felt a lot of the ways the test was
set up were [not] accurate or fair.
Ray also said they are not out of business and they are still shipping
engines and gear boxes. We have not heard from, or about any of these
customers so far.
Paul Lamar ...No rotor no motor.
One of the reasons wingmen always "bingo" before the lead is because he's
jockeying the throttles while the lead is using a stable throttle
setting.
Marinus B. (Ben) Bosma
Exactly.
For those not familiar with the term "bingo" it means I am
low on fuel and I need to go back to base.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.