Subject: Powersport performance and fuel burn
From: Rotary Engine
Date: 5/18/2006, 3:46 PM
To: AAme
CC: editorial@eaa.org



You reported we had a phone call, but apparently
Did not print the points of what I said.
So here it is again in better detail:

Vans chose the speed at 150 kts,
Vans decided the planes should fly at 2500 prop speed.
The Lycoming need the 2500 prop speed to reach 150 kts.

The Powersport [p-port] engine RV's will fly their 150 kts at 2100 prop
speed.
Because the Powersport engine makes 450 lbs/ft of torque at the prop
at 2400 prop with the engine turning 5490 rpm, We CAN reduce the
prop speed to 2100 RPM And still out power the Lycom. Engines.

I don't believe that Vans was slighting the fuel burn test. It just did
not
occur to them that the Powersport engine could match their speed with the
prop turning so slow.

The main point of the Vans test to us was to prove Powersport engines
really
do make more power. Van's interest was performance in all areas.

Vans reported the Powersport engines out climbed and out ran the IO-360
listed at 200 hp. and the Vans Special Built Fanuc 0-360.

Before the tests I asked what mods that special built engine had.
Vans offered no details other than a $8,000.00 fadec system and
other things. So I asked how many of your customers have a similar
equipped engine. Vans said their might be only 1 other.

The questions Vans have repeatly asked the Subaru's are:

1) Why no Subaru or any other engine other than Powersport has
ever flown to Vans and flew tests against them.

2) Why no builder with a Subaru engine has even answered
Vans question as to their flight performance.

3) Van's have asked many times Please come and show us what is the
performance of your engine. Vans said NO one except Powersport
has ever showed up!!

It's really easy to burn less fuel. Make less power, don't climb
or fly fast. Then you don't need to have a large 3 blade prop.
Don't need large air inlet or outlets for cooling. You don't
need to worry about the exhaust temp. or flow rates.

Exhaust:
The exhaust system at the Vans fly-off did not have the completed
upgrade tips. Their for the sound was 91 DB. Recorded at take-off
50 ft under. Current Powersport exhaust now is 81 DB, full power
take-off 50 ft under. Those of you at Oshkosh, (who were close
enough) to hear the 2 Powersport RV-8 will attest to the great
sound. I received ALL positive comments. Most said they sound
like a Quiet Turbine engine. Even some Lycoming guys asked
if we could make their engines sound like that.

The pilot fuel trim feature was added for exhaust and other
development. It allows a 5% trim. The ECU's hold lamdia .94 at
full power takeoff to lamdia 1.00 through 20,000 ft. with no
pilot trim used.

[Lambda 1.00 is 14.7:1 air fuel ratio) Lambda .94 is therefore
13.8:1 which is not quite best power. Best power happens
at 12.5:1. The rotary will continue to run up to at least
18:1 observed on the Mazdatrix dyno and 200 degrees F lean
of peak. Best BSFC is  around 16.6:1. (1.13 Lambda) This is
exactly what I thought was wrong with the Power Sport FADEC.
Tracy Crook cruises at altitude at up to 200 degrees F lean
of peak and with more spark advance and burns about the same
fuel as a leaned Lycoming. It is thought that the reason
this is possible is because the rotary is a rotating combustion
chamber engine and the rich fraction of the mixture is thrown
outboard toward the spark plugs due to centrifugal force.
This makes the rotary naturally stratified charge.

BTW Klaus Savier LSE also uses the same techniques but is
unable to lean the Cont. O-200 to 200 F lean of peak.
See the  attached mixture chart from The Sky Ranch Engineering
manual for more info. PL]

Pilot trim was requested and granted for the following reasons.
At ALT 75% power could still be WOT. If you come to a mountain
and want best power it occurs at 10% rich = .9 lamdia. But best
fuel burn is 10% lean This was a way for the pilot to tell the
system what he wanted. This also allows the customers who do not
purchase our tuned exhaust system to fine tune to the exhaust
system what he actually built. He can record the deviations he
had. We can then make the changes he wanted to his mapping.
Our customers do not fly and need to trim our engines!!

[Can you clarify this Ray? Is the trim 5% or +/- 10%? PL]

Vans has had many years to perfect their best cruise and cooling
Powersport has not. Powersport's 1st cowling had lots of problems.
The worst one is the outlet and exchange width was the same as Vans.
Our mistake, because it needs to be the same width as the working
width of the coolers.

Now we have enlarged and reshaped the cooling duct of our cowling
to cool our 215 horsepower for ground and VX climbs. Next refinement
is our new cowling now permits the oil cooler to be under the engine
and allowing the water rad. to be moved to a more optimum low angled
location. A point that Paul has correctly pointed out for years! Our
earlier cooling duct cowling was not built wide enough. We will add
a flap can be opened during taxi and VX climb. Then after a VX climb
the trailing flap (Not built yet) can be reflected inward to reduce
the height of our opening. This increasing the exit airspeed and
reduce the cooling drag. Presently The RV-8's have no flap
and are over cooling at cruse and thus a drag penalty toward
fuel burn and speed.

The 2 RV-8 tested have not moved their coolers to those locations
yet. When they do they will fly faster and burn less fuel.

Here is the performance as recorded by our 2 California customers
RV-8 builders 1 year ago. They were not trying to improve the fuel
burn or embellish it. They did not list the lower cruse RPM burn
performance.

These do not have the coolers moved, they do not have any cowl
flap or the mods I have explained above.

Aircraft Kit...............................Vans RV-8  (2004)
Engine Cowl Designer.......................Chris Armstrong
Engine Cowl Builder........................James Aviation
Engine.....................................Powersport Rotary
Propeller.................MT Model# 18B Electric Constant Speed
Hp.................................215 @ 6000 ERPM/2620 PRPM
FADEC System...............................Powersport
EFIS System................................Dynon Model D10
Nav & Eng Display..........................Powersport
2:29:/ Reduction Gear Drive................Powersport
Interior Upholstery........................Classic Aero

  VNE   222    EW    1080
  VSFR    57     MGW   1800
  VSFE  53    Est. Time   TBO  3000 HRS
  Wt  1480#   T/O       Dist   191' @ SL (70degrees)
Acceleration Time.....1.8 sec. 2000 ERPM to 6000 ERPM
Initial Roc    90K    2750 FPM
Normal Climb   115K   1850 FPM
Time to Climb   to 8,000'@1:15Kias.5 Min 7 Sec @ 1515lbs
Time to Climb   to 10,000'@1:15Kias.6Min 47Sec @ 1515lbs

Cruise @-------temp 68 degree F
  @ 8000--65% 5100/2300rpm 150K  200Tas 10.4gph  19.23mpg
  @12000--65% 5100/2300rpm 140K  200Tas 9.6gph    20.83mpg
  @8000--75% 5400/2400rpm 156K  208Tas 11.2gph  18.58mpg
  @12000--75% 5400/2400rpm 147K  210Tas 10.5gph  19.96mpg
  @8000--85% 5700/2500rpm 159K  212Tas 11.9gph  19.82mpg
  @12000--85% 5700/2500rpm 151K  215Tas 11.2gph  19.22mpg


N559 JC  Jim Clark  Owner/Builder
N838 SJ  Jerry Gustafson  Owner/Builder


Ray Richardson Owner Power Sport

-------------------------------------------------

Heck I would have needed to tape record the conversation :)

Paul Lamar

Ray,
Thanks for that report, very complete and informative.
I think Paul ( and others) were right to criticize the magazine
article, but your report is much more informative. I feel the
Rotary people are quite sensitive (and rightly so) to information
being distributed, which puts a good product in a bad light.
I am also pleased that Power Sport has re-evaluated their cooling
system lay-out and is prepared to acknowledge improvements.
Keep up the good work!
George (down under)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.