Subject: Ethanol fuel in rotary
From: Rotary Engine
Date: 5/20/2006, 12:26 AM
To: AAme


What is the consensus of burning E85 type fuel in a rotary engine?
Rob Lundahl

It will work fine.
-- 
Paul Lamar ...No rotor no motor.

Will not Ethanol fuel still have the same ice formations problems at
altitude as a conventional piston engine??

Scott Carroll

I have no idea what you are referring to. Up in Canada we used to
put ethanol in our gas tanks in the winter to melt the ice in the
fuel.

Are you referring to a carburetor or fuel injection?

I can see how ice might form on the outside of the intake
runners due to evaporation of the ethanol. That could be
mitigated by "carb" heat. God knows we have plenty of heat :)

Paul Lamar ...No rotor no motor.



Paul,

You raised a good point Paul about evaporation and one that I haven't quite
got my head around is the location of the injectors. If at the end of the
intake manifold ala Mistral and others their will be  a very powerful
cooling effect.  Too much? I am wondering if E-85 or my preferred E-95 will
fall out of the vapor phase by the time it gets the housing.  Wisdom ditates
testing in three locations I guess.   Near the bell mouths, before the slide
throttle, and right near the housing.

BTW did you notice on the AGE 85 report I sent a few months ago that a
engine typically runs 100F cooler on E-85 but uses 10% more fuel until it
reaches  around 13K fee, while  above that density altitude the engine uses
progressively  LESS fuel than if operated on 100LL.  This is good news for
turbo-compounding or a turbo normalized aircraft.  Perhaps this cooler
intake will also equate to a cooler exhaust hence lowering the TITs.

AGE lowers TITs huh?  I better not my wife see what I am writing.  Smack!


Doug Fir



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.