You have to remember that the cooling air follows a circular path around
the cylinder. Since air has mass, it is subject to centrifugal force
making it follow the outside of the curve; that's why it is important to
wrap the cylinder with glass or carbon to keep the air in contact with
the fins. There is a delta T across the fins since the heat source is at
the bottom of the fin, the cylinder, and flows outward, with the fin
tips being the coolest. Another thing to look at is that if you look
down into the fins at the head end, you will see lots of slag and and
roughness at the casting part line. To aid cooling, it helps to smooth
out the slag. Don't smooth the surface too much, for a smooth surface
has a boundary layer that prevents good heat flow. It's important to
have a little roughness. Designers and users of electronic heat sinks
are fully aware of this!
Paul Lipps
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.