Subject: Cozy Girl Lycoming motor mount.
From: Rotary Engine
Date: 5/24/2006, 6:53 PM
To: cozygirrrl@aol.com, AAme

http://www.cozygirrrl.com/menupage.htm

Chrissie, this will also work but it is so out
of the mainstream you might have trouble
convincing people to try it. All shear and torque
loads are taken by the two lower rubber bushings.

The top rubber bushings and two MM tubes deal only with
the engine moment about the firewall.

One tube at the top would do as well but there are usually
two firewall hard points up there.

Basically it is the same as our rotary engine Schertz
beam motor mount.


Here are the rod ends to use.

As is you will get cracks at the junction of the top
tubes and firewall hard points.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.