Subject: Windmill start with PSRU? With turbo compounding?
From: Rotary Engine
Date: 5/25/2006, 3:09 PM
To: AAme


- Is it possible to restart a rotary in flight using windmilling RPM through
the PSRU?  I don't recall seeing this discussed previously.

- Also, will turbo compounding change the situation?  I'd imagine the
windmilling RPM will be reduced due to the prop's driving of the turbine.


This is not a big deal, since we'd normally just use the starter to crank
things over in flight.  In case of total electric failure (incl battery
backup), no restart would be possible anyway unless the motor incorporated
magneto ignition.   But, since folks will ask these questions, I figured I'd
ask early.

Thanks .

Mark Waldron

Wind milling depends on air speed.
I'll search for some numbers later today.

Turbo compounding will not change this because of the
one way clutch on the output shaft of the turbo compound
gear box. In other words it is not possible for the e-shaft
to drive the turbine gear box. The turbine gear box must
be rotating faster than the e-shaft before a connection is
made.

Paul Lamar ...No rotor no motor.



Hi Paul,

  Here's the impossible question, but I'll ask it anyway in hopes you may
have some guesstimate.  When (not if,) the turbo compound engine becomes
available to us, what is it likely to cost to build one up or buy it
outright?  --  Just trying to plan my budget early :-)

Robin

Not the foggiest yet Robin. I have not recoeves a bill from
the machine shop.


My wild ass guess is $1000 +/- $200 but I am not going
to build and offer them. I am hoping somebody with
deeper pockets than I will take over R&D and production.
I am not looking to make any money from this in any way.
Part of the reason I am going to the AIAA where the movers
and shakers of the aircraft industry reside.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.