Giffen Marr wrote:
Paul
Am I to understand that the TC Drive is to be driven by a shaft from the
Turbo compressor? If so, aren't shaft rotational speeds of 60k to 80k
going
to present a problem?
Giff Marr
LIV-P/20B 45%
What problems did you have in mind? This is what I tink I am going
to use in the 1/2 inch size.
Paul, you are joking right?
Mark W.
Opss I forgot to attach it.
--
Paul Lamar ...No rotor no motor.
Hi Paul,
It was attached the first time.
You don't seriously think you can attach two shafts rotating at 80K with
this do you?
Mark W.
Why not?
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.