Hello Paul.
Here is a sketch of my set up. Recall the 5x6 oil cooler now
fills one nostril and I am moving, rotating it back and up
against the top cowl. Since I have a complete scrap cowl I can
cut and try with abandon. I will take pressure readings with the
original set up on the good cowl, then on the scrap cowl, then
start cutting and pasting. Do you have suggestions for initial
louver size and angles at the three locations shown?
Thanks
Peter
That looks like a low pressure area at point 1.
That looks like a flap and not a louver :)
Make the flap the same size as the cooler.
BTW please save your scans as jpg and not pdf.
Less work for me.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.