> Dear Paul,
>
> Thank you for editing and distributing such an
informative newsletter.
> I would like to ask whether you (or other
subscribers) know of a
> reduction box which combines the output of two
rotaries into one prop
> shaft, while enabling individual operation /
sut-down of each of the two
> engines?
>
> Thank you very much, again.
> Ronen.
>
> I don't know of one. Sounds like a fun project. Is
this for an aircraft
> or a boat?
>
> Paul Lamar ...No rotor no motor.

Paul,

Seems like I remember a couple of South American
brothers had
something along those lines that was featured a few
of years back in
one of the aero magazines

Terry

Ronen & Paul
There was just such an installation in a very ugly car
at SevenStock a couple yrs ago. It did couple the
engines but I don't know if it provided reduction. You
must have seen it Paul; I know Robin did. I'm sure it
was one off made by the fellow showing the car. And I
can only suggest contacting the show organizer to get
a lead.

regards, Robert

Yes I remember that car.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.