Subject: Redrive oil supply & return
From: Rotary Engine
Date: 5/31/2006, 9:37 PM
To: AAme




          Hello Paul-

          I found the oil port you were suggesting for feeding the RD1C
    on the
    top
          of the #1 end housing (aka front housing in the car).  Initially I
          couldn't tell if it was an oil port or a coolant port.  I hand
    propped
          per your suggestion to get oil pumped through the engine &
    cooler, and
          when oil came welling up out of the mystery port (a-la Jed
    Clampet) I
          got my answer.

          I'll be adding a return port to the oil pan (btw -- you should
    add one
          to the plans, since everyone will need it).  I am assuming it
    is wiser
          to add it to plugs side of the engine instead of the (hot) exhaust
          side.  Do you think the supply & return lines should be rigid
          tubing, or
          flexible lines?

          Mark Supinski

          The turbo engine front (car) cover has a port for oil return
          from the turbo you can use. Just below the apex oil metering
    pump.

          I would use Teflon lined double SS braided AN hose. This is your
          life you are fooling with :) Some use rigid aluminum line but they
          are asking for it.

          Paul Lamar ...No rotor no motor.



    Paul-

    I searched the front cover, and this is the only likely candidate I
    could find for the oil return port (pic 1).  Presuming this is the
    correct port - what will happen when I remove this cover?  Will oil
    come
    pouring out?  I assume that I should just get an AN fitting welded onto
    the cover & reattach.

    For completeness sake, the oil supply port is pic 2.

    Mark Supinski

    Too high for oil to pour out. Strange cover however.
    Please unbolt it and take another picture. I do not recognize
    the cover. Looks like two piece.

    The oil supply point is correct.

    -------------------------------------
    Cover over the oil metering pump?

    You can also drill and tap a hole in the base of the rotor housing
    on the
    plugs side of the engine for the oil return.
    Bill Schertz


Here's a picture from behind the cover , as well as the back of the  cover.

Mark Supinski

OK the hole you see without the shaft is a vent hole
so line up your return line with that hole. A bit
on the small but it should work. As far as I know that
is the only way to get oil back in the engine without
taking the oil pan off or the engine apart.

-
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.