Subject: Exhaust turbo manifold and muffler.
From: Rotary Engine
Date: 7/17/2006, 9:52 AM
To: AA-me





> >> > Bill,
> >> > I just can't seem to visualise in my mind, what you are saying -
a flat
> >> > plate restricting the exhaust flow, seems counter productive?
> >> > A small drawing would help!
> >> > George (down under)
> >
> >> George I'll do a drawing. The way to think about it is this,
> >> think of the standard round canister with one flat slice on the
primeter.
Very little restriction but it forces the flow to be turbulent. The cool
tube concept could still be used.
> >> Bill Jepson

> Ok George, Here's the muffler drawing I promised.
> I hope all will now become clear!
> Bill Jepson

Bill,

Are you still out there buddy? I thought of using your design and mounting
the turbo for the turbo compound system in the center of the area that you
show as being flat except I will keep it round. I think for turbo
applications it would be better to keep the air smooth and so place some
curved baffles within the pipe to direct the gases around and towards the
center.

I like the idea of grabbing some cabin heat from this design or at least in
the testing phase to be able to lower the TIT and record the power losses.
If the turbo compound is disengaged when taxing then it would be nice to
have something to quiet the system down as well. Depending on the turbo
used I would still keep the down pipe perhaps exiting closer to the turbo
flange and install a waste gate in it. Still thinking about it. RAJAY
turbos have a great reputation in aircraft use and have the operating range
we are looking for. I don't know the internal design or if the exhaust path
is axially divided as mentioned on page 19 and 20 of Huge MacInness' book
TURBOCHARGERS for good torque at lower speeds. RAJAY aircraft turbine
housings are made with high $$$$$$ 25-30% nickel content are usually
because
of the high heat load encountered.

No, Paul I haven't sold the 2nd gen turbo yet:) I know what you are going
to say and it may be wise to start testing with that one first. I wish it
was bigger and slower though as I think the standard unit will be rapidly
toasted operating it in the 80K range. Perhaps we can change to a higher
A/R
housing?

Cheers

DougFir


Doug,
I am certainly still here! The set up I drew for George was for a
muffler used on a normally aspirated engine. This arrangement would be
bulky to use as a manifold for a turbo. I would be glad to work with you
if you need a custom layout. The jpeg you posted is a variant of the
muffler used on the Jabaru which is very quiet.
Bill Jepson


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.