Bill,
I just can't seem to visualise in my mind, what you are saying - a flat
plate restricting the exhaust flow, seems counter productive?
A small drawing would help!
George (down under)
George I'll do a drawing. The way to think about it is this,
think of the standard round canister with one flat slice on the primeter.
Very little restriction but it forces the flow to be turbulent. The cool
tube concept could still be used.
Bill Jepson
Ok George, Here's the muffler drawing I promised.
I hope all will now become clear!
Bill Jepson
Bill,
Are you still out there buddy? I thought of using your design and mounting
the turbo for the turbo compound system in the center of the area that you
show as being flat except I will keep it round. I think for turbo
applications it would be better to keep the air smooth and so place some
curved baffles within the pipe to direct the gases around and towards the
center.
I like the idea of grabbing some cabin heat from this design or at least in
the testing phase to be able to lower the TIT and record the power losses.
If the turbo compound is disengaged when taxing then it would be nice to
have something to quiet the system down as well. Depending on the turbo
used I would still keep the down pipe perhaps exiting closer to the turbo
flange and install a waste gate in it. Still thinking about it. RAJAY
turbos have a great reputation in aircraft use and have the operating range
we are looking for. I don't know the internal design or if the exhaust path
is axially divided as mentioned on page 19 and 20 of Huge MacInness' book
TURBOCHARGERS for good torque at lower speeds. RAJAY aircraft turbine
housings are made with high $$$$$$ 25-30% nickel content are usually because
of the high heat load encountered.
No, Paul I haven't sold the 2nd gen turbo yet:) I know what you are going
to say and it may be wise to start testing with that one first. I wish it
was bigger and slower though as I think the standard unit will be rapidly
toasted operating it in the 80K range. Perhaps we can change to a higher A/R
housing?
Cheers
DougFir
I think Dave Leonard and John Slade have already
proved it is primarily not the heat that does in the stock 2nd gen
turbo but the excess turbo RPM. The turbine blades were coming off and
the turbine wheel was coming off the shaft. A contributing factor
was the too small waste gate. The waste gate was designed
for a quiet automotive muffler system and catalytic converter.
The third factor is the automotive turbine section is designed for
excess HP in order to accelerate the compressor rapidly.
Therefore the turbo charger over revs and fails the turbine blades.
The fix is to load down the turbine with a bigger compressor as Dave and
John have done or tap some of that excess HP for the turbo compound.
The excess heat does not help of course.
--
Paul Lamar ...No rotor no motor.
Paul
Yea I hear you. I noticed most of the RAJAY aircraft turbine operate at
very low Rpms. Do you happen to know the internal configuration of the
those types? Axially split? vane diffusers? My only reservation about
using the stock IHI turbo for a turbo compound is that its 'sweet spot' is
over 100K necessitating running the traction drive faster. I would prefer
to keep it at or under 80K rpm. Operating the standard turbo off ideal rpms
may heat it up too much. Fine for dyno work or proof of concept testing I'm
sure since we can monitor it carefully.
DougFir.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.