Below is a picture of how Tom Parks did his turbo. No spin that I
know of
but more of a log manifold. Nice Inconel set up. Note how the waste
gate
connects.
For the spin muffler, heater combi I have no idea however of
dimensions of
the inner pipe, baffles and surrounding chamber and thickness of
said parts.
I would appreciate your advice. I have stainless 316 and TIG welder
in hand
waiting to mock up a prototype. Assume a four bolt pattern exhaust port.
Final design after testing would be in Inconel where appropriate.
Thanks
DougFir
Doug,
For the highest energy recovery the manifold should be SHORT period.
That being said, I can see where Tom Parks went with his manifold. The
canister volume should quiet the system some.
I need to interject something for your thoughts. Why would you ever
want to run an exhaust muff (or cool tube) heater? My personal thinking
is that I would NEVER run an exhaust mounted heater if I had a logical
alternative. With a water cooled engine you can easily plumb a
lightweight heater core and 12V fan. You may have discussed your reasons
in an earlier e-mail that I missed. CO poisoning is an insidious killer,
avoid possible exhaust connections to the cockpit if you can.
The intent of the cool tube in my earliest drawings was to draw air in
using the exhaust pulses around an annulus. Mistral's latest efforts
look very much like the VAM design, though they don't bother with a
tangential entry. That makes the muffler easier to make and should
transfer more energy into the center tube. What we were shooting for
was to draw cooler air into the exhaust stream and lower the exit
temperature and quiet the system overall. When they ran the earliest
system at Tracy's they didn't run the tailpipe which ruined the attempt
to pull in air and was too loud. (which I would have expected without
the tailpipe) The area of greatest restriction was removed along with
the tailpipe. I don't think you would benefit much with an internal tube
on the turbo-compound. In inconel 1.5 mm (.06in) is a generous
thickness. With stainless I would run 321 if you can get it. 316 won't
like the high temps as much and will need to be from 2.2 mm (.09in) in
non-direct areas to 4 mm (.120in) in the directly blasted areas and the
exit tubes. The advantage of the thicker stainless is that the exhaust
won't "ring" the manifold as much and it will be quieter, though heavy.
Those thicknesses are for normally aspirated engines: with a heavy turbo
hanging on the manifold thickness will probably need to be 4 mm and
greater. You need to post a hand sketch of what you want the system to
look like then Paul or I might be able to clean it up for you.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.