Paul,
    This is the aluminum oil pan for the renesis engine with the beam
engine mount. Tell me what you think.
Ed

Looks good Ed. Do you have enough room for the Schertz beam?
Got a picture of the oil pump pickup tube?

Paul Lamar ...No rotor no motor.

Paul,

Ed built this one for me, but I handn't had a chance to post the pix
yet.  The center 'strut' is just temporary, to help keep the side
flanges in place during welding.  This will get cut out before installation.

This design allows for both a front and rear 2" wide Schertz beam.  It
is 4" deep, and calculated to hold 5-6 quarts, but I haven't measured it
yet.

The oil pickup tube will be a 13B version, which will fit on a Renesis
engine with mininal modification (a minor bolt hole issue).  The tube
will extend a little over 3" down into the pan.

Ed does great work!

Scott Gettings



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.