With 25 inches in width, how long should my radiator be with excess
capacity for the one inch thickness you recommended?

Is the tube out the side of the oil filler tube for breathing?

With only six inches between the exhaust side of the engine and the
engine mount I'm going to be hard pressed for manifold space.

How did Ian Beadle fasten the aluminum plate to the cut down intake
manifold? I was thinking of tack welding it in several places and laying
a bead of JB Weld around the rest.

How much is the aluminum oil pan for the Renesis? I can't use one as
deep as the one shown before.

Will the automatic flywheel for the 13B work on the Renesis?
More questions, later, I'm sure. H. Karibian


------------------------------------------------

The rule of thumb is a 600 cubic inches core.
600/25 = 24 inches. If a duct and diffuser is perfect
that rule of thumb may drop to 500 cubic inches and the length
will drop to 500/25 or 20 inches.

Yes the tube out of the side of the filler neck is normally
connected to the intake manifold to burn the vapor from the
crankcase.

Why only six inches? The Schertz beam should be
30 inches long. 30"- 12" (engine width) = 18". There should
be about 8 inches clearance according to these Thorp 3Ds.

Ian will have to answer that one.

Ed Klepeis needs to answer the next one.

I am not sure about the 13B flex plate working on the
RX8 engine but I don't think so. The counter weights
won't work for sure as the rotor weights are slightly
different. Mazdatrix carries the flex plate and counter
weights for the RX8 engine.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.