Subject: LS1 verses 3rd gen turbo rotoary in a 3rd gen RX7
From: Rotary Engine
Date: 8/2/2006, 9:50 PM
To: AA-me



        I am not talking about the exhaust sound. Just the feeling
        you get by the apparent vibration levels. I have stood next to
        both of them in dyno rooms.

        Are you talking about 2 hour NASCAR racing or 15 minute sprint car
        races. As I understand it NASCAR engine breath through a four
   barrel
        carb and a restrictor plate

        Paul Lamar ...No rotor no motor.

Paul,
I believe the rotary is the better engine, especially when we work out
the aluminum end plates. I must correct some misconceptions though. The
new LS-1 engine is a very nicely built engine as V8 piston engines go.
The bottom end is beefed up considerably from the cast iron small block.
The engine uses a full skirted lower end with 4-bolt cross bolted mains
stock. Looks like a miniature version of the Chrysler Hemi. All very
nice of course but we aren't really interested in Chevys here anyway.
Besides there is still the limited area of the standard rods...etc. I'm
amazed that the RX7 conversion idiot thought it would be better with the
chevy! If the dope had put half as much into uprating the rotary as he
spent on the conversion he probably could have doubled the V8s numbers
and had money left over!
Bill Jepson


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.