> > > > Hi,
> > I got a problem.
> > I ordered a Renesis engine from Rupert.
> > > > I try know to make a engine stand head before the engine arrives, > > like the one in the attachment.
> > > > Can anybody tell me the dimensions for this stand head, especially > > the distance between the bolt holes?
> > I have no engine available, so I can't measure it myself.
> > > > Thanks in advance.
> > > > Kind regards
> > Thomas
> > > > That is my problem too. I don't have an RX8 engine lying
> > around. I might be able to measure my RX8 engine in my RX8
> > car but I am home and the RX8 is in the hanger. I might
> > be able to help you after six o clock my time.
> > > > -- > > Paul Lamar ...No rotor no motor.
> > > If your stand has the adjustable "Z" type mounting brackets, you may be
> able to bolt it right to the engine.  I bolted these brackets to the
> 10mm bolt holes on the side of my Renesis without an intermediate plate.> > I can get these measurements if no one else has them handy.
> > Scott Gettings

I added a pic of my engine stand.
I'm not sure if the factory stand head will work on a renesis.
Did you mean that with Z-type?

Thomas Rebhan

This is about what mine looks like.  The "Z", movable brackets on my
mount are big enough for a 10mm bolt.  I got some long bolts and
adjusted the Zs over the 10mm block holes and was able to get 3 bolts
into the block without any problem.  This will depend a little on the
exact length and base plate of your unit.

I can get the exact measurements this weekend if still needed.

Scott Gettings

If we are talking about the rear housing bolt holes I have those
and here they are.

Paul

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.