> > Hi,
> I got a problem.
> I ordered a Renesis engine from Rupert.
> > I try know to make a engine stand head before the engine arrives, > like the one in the attachment.
> > Can anybody tell me the dimensions for this stand head, especially > the distance between the bolt holes?
> I have no engine available, so I can't measure it myself.
> > Thanks in advance.
> > Kind regards
> Thomas
> > That is my problem too. I don't have an RX8 engine lying
> around. I might be able to measure my RX8 engine in my RX8
> car but I am home and the RX8 is in the hanger. I might
> be able to help you after six o clock my time.
> > -- > Paul Lamar ...No rotor no motor.


If your stand has the adjustable "Z" type mounting brackets, you may be
able to bolt it right to the engine.  I bolted these brackets to the
10mm bolt holes on the side of my Renesis without an intermediate plate.

I can get these measurements if no one else has them handy.

Scott Gettings

I added a pic of my engine stand.
I'm not sure if the factory stand head will work on a renesis.
Did you mean that with Z-type?

Thomas Rebhan

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.