Hi Paul
Here are the pictures of my cooling system and the plane.
Changing from inside air to the engine to outside added 500 rpm to the
previous max. in flight of 5400.
Changing the 68X86 Prince P tip prop. to a 68X78 P P tip took the rpm to
7200 at 150knots. Previous was 140knots.
The cooling was better with the new prop. Around 100C (212) for both oil
and Evans Plus. At full throttle.
The next step is to redo the inlet duct as the temporary one is quite
restrictive, only 50mm diameter from the throttle body 75mm.
I will make a fiberglass ram air snorkel.
How big should I make the inlet to the ram scoop?
Note: Please hold the emails after the 11 th as I am off to Melbourne. I
was going to pop into Cobra but perhaps that might not be such a good
idea now.
Ian Beadle, 5 hours up and counting.
I'll discuss the carb air (for the lack of a better term) first
in the interest of bandwidth and simplicity.
Looks like you will need two 90 degree bends to maintain 75
mm diameter to place the 75 mm diameter ram air scoop outside
the side of the cowl like Dave Leonard did. Last picture.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.