George,
I am not sure what you are saying here. My statement was:
IIRC; " the 6 port Renesis side gears have different tooth design than
4 port Renesis side gears".
So, if you buy a 4 port Renesis you get the old 13b side gears.
Guru redesigned the side gears in their high performance engines a few
years back .
FWIW, Dave McC
That's right Dave, as the chief engineer of Guru informs me - that's only
tip relief, which provides a slightly better meshing.
I'm led to believe that the additional tip relief is in all RX8 engines
which follows the modifications of the high performance engines.
That information is to best of my knowledge!
I purchased an RX8 stationary gear for my single, but in reality I could
have used an RX7 without problems.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.