paul

Thanks for the rendering I've always wanted one of those.
Did you use Rhino? If so could you send me the file? Also,
what are the dimensions of that formula one style intake.
I would like to make a couple. I have some pretty good ideas.
I think I can turn the blank on my Lathe, and then lay up some
glass over it.

Tony

If you can stand the ugly factor make the runners 24 to 28 inches
from side port to trumpet mouth :) The butterfly throttle can be in
the air scoop cum plenum. The opening should be about 3 inches
in diameter. The native Rhino file is too big to email.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.