Joe and Paul
what is version 12 slide throttle mean? I'm a little ignorant as
I wasn't planning on doing the P-port thing untill now . I don't
want to assume anything. Also Paul I got your zip files just fine.
They will work with no problem.
I'm going to anodize all my slide
throttle parts, either blue and gold, or purple and gold,and I'll
use only stainless steel socket head cap screws predrilled for
safety wire. I don't know how much each assembly will cost but
I think it'll be very affordable for what you are getting. I'll
be doing all my own anodizing.
Tony
Version 12 main change over Ver 11 was the incorporation of
the throttle cable anchor. I also squared it up to make it easier
and cheaper to make.
One thing before you go into mass production Tony is get
a throttle cable and check the fit. I am not sure about
the length. Mark has one. Mark what is the lenght between
the end of the 10-32 rod when fully extended and the
center of the threads that anchor the cable housings?
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.