I got some junk housings and am ready to bore now that I have been
released
from the housing building project:) You mentioned 3rd gen housings are
preferred. Which housings and why?
DougFir
Looking at pics of my "new" 4-port renesis motor, Id guess that 13B's
are better subjects for p-porting for several reasons: neither intake
nor exhaust ports are cut in the Renesis rotor housings, so, extensive
rework will be needed in the tweener housings to fill in the 6 existing
side ports, and at least 4 new ports need to be bored, and manifolds
need to be fabricated. I have not seen anything on p-porting exhaust
ports so far...? I dont know for sure , but Id guess an exhaust port
cut similar to the intake drawings, would be very noisy and hard on
exhaust manifolds.
The other disadvantage Ive seen discussed involves higher heat
generation rates (through larger side port surface area). The Renesis
has a slight weight advantage and possibly will provide better
efficiency at low/mid throttle settings.
Paul, a related question: do you have any information on street porting
the Renesis motor? Id guess there might be some flow and timing
advantages at the higher rps we will be running these motors.
Do you happen to have a list of what updates are suggested for aircraft
use of a new Renesis motor- along the lines of applying silicone to the
long bolts, etc?
Mike Parker
I think Bruce Turrentine has ported a RX8 four port engine.
Don't let him put after market apex seals in it however :)
Perhaps Racing Beat or Mazdatrix have RX8 porting templates
available. I think you will be limited to about 200 HP at 7500 RPM.
The RTV red silicone spiral on the tension bolts has not changed.
You still need it on RX8 engines. As far as I know no other
changes are necessary.
If I were p-porting an RX8 engine I would leave the side exhaust
ports as is. That would be a real can of worms trying to
plug those up due to the high heat in that area. I could be
wrong. A simple steel plate bolted on the output port might just
work.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.