>> Here are some more pics.
>> Notice how the short tube seats in the counter bore
>> just short of the steel liner.
>> You can use a high quality 1.5 inch hole cutter
>> instead of this shell mill to rough it out before
>> final boring.
>> -- Paul Lamar ...No rotor no motor.
>
>
> This part has people scared but there is nothing to it. It has been
> awhile but I think I drilled a 1.25 i.d. pilot hole and then opened
> up with a boring head.
> . It does not take long. One practice hole and you will have
> confidence to do the real thing. Jerry
Here is an interesting thread that Cary Beasley found where the builder
shows using a hole saw to make the final hole.
http://www.rx7club.com/showthread.php?t=144200&page=1&pp=15
<http://www.rx7club.com/showthread.php?t=144200&page=1&pp=15>
Even if you plan to finish with boring tool, the hole saw would be
cheaper than a big end mill and safer than a fly-cutter to make the
rough cut. You will need a high quality bi-metallic (such as Dewalt)
hole saw. Drill the pilot hole as a separate operation. Replace the
pilot drill in the hole saw arbor with a solid rod to guide the hole saw.
It occurs to me that if you mount the hole saw in the mill and gently
dress the tooth set on the outer edge with a die grinder, that it would
make a hole with a surface finish very nearly as good as the boring
tool. The tube could then be turned to fit to the hole. One benefit
of doing it this way is that you could set it up for the cut with a much
less rigid angle plate.
Aubrey
Aubrey, most hole saws are nowhere near accurate enough on-center. They
will cut an oversize hole since the center rarely aligns exactly with
the arbor.
Bill Jepson
Yeah, I know, Bill. That is why I was mostly interested in the surface
finish. The tubes would need sizing to whatever hole the saw makes.
Most Do-It-Yourselfers have a small lathe and could turn the tubes to
fit. But, few hobbyists have a large enough mill and the tooling and
fixtures to do it the way Paul's photos show it being done. I was
applauding the resourcefulness that was apparent in using the simpler
tooling. Using the lathe as a horizontal boring machine was a neat
idea.
Aubrey
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.