The pitch oscillations, or porpoising, that your airplane is exhibiting
could well coming from the stabilator -- and the fact that you don't have an
anti-servo tab. A lot of planes with stabilators have this problem,
including early Cessna Cardinals, Beech Musketeers, Tharp T-18s, etc.
Planes with a stabilator have more pitch sensitivity because there is more
pitch authority with the whole tailplane moving, instead of just half, as
with an elevator. The anti-servo-tab acts opposite to the movement of the
stabilator and increases control pressure, which is what you want when you
have pitch sensitivity.
...........
The thing to remember is that a plane with a stabilator is inherently more
sensitive in pitch. I would proceed very carefully and methodically from
here. If and when you do install that anti-servo tab, make sure you have
good guidance from the kit manufacturer and follow the instructions.
Make sure that all rigging is set properly, including wing incidence -- and
that CG is where it should be.
Gordon.
FWIW: I agree with all the previous comments with this thread. We have a
local builder of a plans-built Turner T-40A, which has a stabilator and
anti-servo tab. It was almost unflyable on first test flight. Only the
skills of a highly experienced pilot got it down OK.
The builder obtained more detailed specifications for the stabilator/
anti-servo tab geometry: pivot points, C.G., etc. Moving the pivot point of
the anti-servo tab actuating rod approximately 3/8 of an inch made all of
the difference. The plane now flies nicely.
Double check all stabilator and tab specifications before further flight
attempts.
Good luck!
Tom Parkes
Prescott, AZ
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.